Documenting Measurements
The measuring tool begins to take measurements as soon as it is switched on and does so continuously until it is switched off.
To save an image, point the camera at the required measuring object and press the "Save" button (14). The image is saved in the internal memory of the measuring tool. Alternatively, press the measuring button (23) (pause). The measurement is frozen and shown in the display. This enables you to carefully view the image and to make retrospective adjustments (e.g. to the colour palette). If you do not wish to save the frozen image, restart measuring mode by pressing the measuring button (23). If you wish to save the image in the internal memory of the measuring tool, press the "Save" button (14).
You can record a voice note to keep a record of environmental conditions or additional information about the saved thermal image. This information is saved in addition to the thermal image and visual image and can be transferred at a later stage.
It is recommended that you record a voice note in order to keep better documentation.
The voice note is recorded in the gallery. Proceed as follows:
- To access the gallery, press the left-hand function button (17).
- Press the Func (9) button. The recording will start. Record all the relevant information.
- To end the recording, either press the Func (9) button again or press the right-hand function button (10).
- To cancel the recording, press the left-hand function button (17). After you have made the recording, you will be able to listen to the voice note.
- To listen back to the recording, press the Func (9) button again. The recording will be played back.
- To pause playback, press the right-hand function button (10). To continue playing the paused recording, press the right-hand function button (10) again.
- To stop playback, press the left-hand function button (17).
To record a new voice note, delete the current voice note and then start a new recording.
When recording, please note the following:
- The microphone (16) is located behind the keyboard next to the microphone symbol. Speak in the direction of the microphone.
- The recording can last a maximum of 30 seconds.
Proceed as follows to call up saved thermal images:
- Press the left-hand function button (17). The most recently saved photo now appears in the display.
- Press the right-hand (11) or left-hand (15) arrow button to switch between the saved thermal images.
The visual image has been saved alongside the thermal image. To call up the visual image, press the down arrow button (13).
You can also display the thermal image taken as a full-screen image by pressing on the up arrow button (8). In the full-screen view, the title bar is hidden after 3 seconds so that you can see all the details of the thermal image.
You can use the up arrow button (8) and the down arrow button (13) to switch between views.
Switch to the gallery view to delete individual or all thermal images:
- Press the right-hand function button (10) under the waste paper basket symbol. A submenu will open. Here you can select whether you want to delete only this image, only the corresponding voice note (if you have recorded one) or all images. If you want to delete only this image or the voice note, confirm the process by pressing the Func (9) button.
- If you want you delete all images, press the Func (9) button or the right-hand function button (10); you can also confirm the process by pressing the right-hand function button (10) or cancel the deletion by pressing the left-hand function button (17).
Data fragments of the images remain stored in the memory and could be reconstructed. You can select <Tool> → <Factory settings> in the main menu to permanently delete.