Product features

The numbering of the product features refers to the diagram of the power tool on the graphics page.

(1)

Guide groove for parallel guide

(2)

Scale for spacing between saw blade and parallel guide

(3)

Angle guide

(4)

Recessed handles

(5)

Guide groove for angle guide

(6)

Protective cover

(7)

Riving knife

(8)

Saw table

(9)

Parallel guide

(10)

V guide groove on the saw table for the parallel guide

(11)

Mounting holes

(12)

Carrying handle

(13)

Saw table expansion

(14)

Fixing clip for the GTA 600 saw stand

(15)

Clamping handle for saw table expansion

(16)

Locking lever for setting the bevel angle

(17)

Hand wheel

(18)

Crank for raising and lowering the saw blade

(19)

On/off switch safety flap

(20)

Hex key (2 mm)

(21)

Hex key (5 mm)

(22)

Ring spanner (23 mm)

(23)

Push stick

(24)

Adjusting screw for adjusting the clamping force of the parallel guide

(25)

Table insert

(26)

Saw blade

(27)

Magnifying glass

(28)

Profile rail

(29)

Cable holder

(30)

Holding clip for storing the additional parallel guide

(31)

Chip ejector

(32)

Dust extraction adapter

(33)

Bracket for storing the protective cover

(34)

Clamping lever for riving knife

(35)

Positioning pins for riving knife

(36)

Recesses for table insert

(37)

Clamping lever for protective cover

(38)

Guide pin for protective cover

(39)

Clamping handle of the parallel guide

(40)

V guide of the parallel guide

(41)

Additional parallel guide

(42)

"Additional parallel guide" fastening set

(43)

Guide rail of the angle guide

(44)

"Profile rail" fastening set

(45)

Fastening screw for chip ejector

(46)

Clamping nut

(47)

Spindle locking lever

(48)

Clamping flange

(49)

Tool spindle

(50)

Mounting flange

(51)

Bevel angle indicator

(52)

Scale for bevel angles

(53)

Locking knob for all mitre angles

(54)

Angle indicator on the angle guide

(55)

Saw table spacing indicator

(56)

On button

(57)

Knurled nut for profile rail

(58)

Cross-head screw for setting the 0° stop

(59)

Stop for 0° bevel angle

(60)

Screw for bevel angle indicator

(61)

Cross-head screw for setting the 45° stop

(62)

Stop for 45° bevel angle

(63)

Hex socket screws (5 mm) on the front for adjusting the parallelism of the saw blade

(64)

Hex socket screws (5 mm) on the rear for adjusting the parallelism of the saw blade

(65)

Screw for saw table spacing indicator

(66)

Hex socket screws (5 mm) for adjusting the parallelism of the parallel guide

(67)

Screw for parallel guide spacing indicator

(68)

Adjusting screws for table insert

(69)

Bracket for storing the "additional parallel guide" fastening set

(70)

Holding clip for storing the dust extraction adapter

(71)

Securing nut for the ring spanner and for hanging the push stick

(72)

Bracket for storing the hex key

(73)

Holding clip for storing the angle guide