Changing the drilling angle

• Pull the plug out of the socket before carrying out any work on the power tool.

• Always retighten all the screws after making adjustments to the drill stand.

Loosen the lower screw (24) on the drilling angle adjuster using an open-ended spanner (width across flats 17 mm) and remove it.

Loosen the upper screw (21) using an open-ended spanner (width across flats 17 mm).

Loosen the clamping nut (27) using an open-ended spanner (width across flats 24 mm). Set the drill stand to the required drilling angle.

Retighten the clamping nut (27) using the open-ended spanner (width across flats 24 mm). Tighten the upper screw (21) using an open-ended spanner (width across flats 17 mm).

• The drill stand must not be inserted until the clamping nut (27) and screw (21) of the angle adjuster have been retightened.

After drilling, put the drill column (20) back in the vertical position (drilling angle of 0°) by carrying out the steps above in reverse order. To do this, you will need to refit the lower screw (24) and tighten it using an open-ended spanner (width across flats 17 mm).