Starting Operation
- Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
- To start the power tool, push the on/off switch (4) to the right.
- To switch off the power tool, push the on/off switch (4) to the left.
At low temperatures, the power tool will take a certain amount of time to reach its full impact performance. You can shorten this warm-up time by tapping the power tool's inserted application tool on the ground once.
The electronic control enables continuous speed preselection in accordance with the material.
The constant electronic control keeps the preselected impact rate almost constant when alternating between no-load and loaded operation.
- Select the impact rate with the thumbwheel (7) according to the material.
You can lock the chisel in 12 different positions, allowing you to select the optimum working position for each task.
- Insert the chisel into the tool holder.
- Push the chisel adjustment ring (3) forwards and turn the chisel to the required position with the chisel adjustment ring (3).
- Release the chisel adjustment ring (3) and turn the chisel until it audibly clicks into place.