Transport position and work position of the saw blade
Transport position
- Remove the protective cover (3), remove the table insert (6) and place the riving knife (5) in the bottom position. Reinsert the table insert (6).
- Turn the crank (19) anticlockwise until the teeth of the saw blade (27) lie below the saw table (2).
- Push the saw table expansion (8) in fully.
Push the clamping handle (24) down. This fixes the saw table expansion in place.
- Remove the protective cover (3), remove the table insert (6) and place the riving knife (5) in the bottom position. Reinsert the table insert (6).
- Turn the crank (19) anticlockwise until the teeth of the saw blade (27) lie below the saw table (2).
- Move the guide rail (25) fully in.
Push the clamping handle (24) down. This fixes the saw table expansion in place.
Work position
- Position the riving knife (5) in the top position directly over the centre of the saw blade, insert the table insert (6) and fit the protective cover (3).
- Turn the crank (19) clockwise until the top teeth of the saw blade (27) are approx. 3−6 mm above the workpiece.